Vader's Vault Unstable Sleeve Set hotsell

For just the side blades go here: https://www.etsy.com/sg-en/listing/761396619/unstable-sleeves-for-vaders-vault-blades
For Galaxy's Edge/Savi's Workshop Lightsabers go here: https://www.etsy.com/listing/774810777/galaxys-edge-unstable-sleeve-set

These sleeves are designed for the Neopixel side blades for Vader's Vault fx lightsabers to emulate the appearance of Kylo Ren's unstable blades as seen in The Force Awakens and The Last Jedi.

They fit both the Ren Crossguard and the Vanquish.

They hotsell are printed in a translucent flexible TPU filament to allow for maximum light diffusion and durability and should stand up to duelling.

The main blade sleeve is about 9 inches long and will fit a 1 inch OD blade.

The side sleeves are around 4.5 inches long total and leave the bottom section clear for insertion into the blade holders. Depending on the saber model you have they may need a little trimming as the blade depths are not the same on different designs.

PLEASE NOTE: While these will technically fit on the blades that originally came with the korbanth cross guard 2.0, recent pre-installed neopixel hilts from korbanth have their blade holders drilled out and use regular 7/8 blade stock. These sleeves WILL NOT fit on those 7/8th blades :)

I have done my best to tune the tolerance so that these will stay on the blades with friction and they are heat formed over actual VV side blades. While I sent prototypes to VV and several others to ensure ideal fit I have had one report that they were too loose. If the blade is too loose to stay on with friction a small dab of E6000 or hot glue will hold it in place whilst still being removable when desired.